9TURBO MT4-EL Ver.2

Installation Manual



Please Note * * * Any modify on your transmitter, It will cause your transmitter to warranty void.
if you do follow this modification. it's your own risk for any damage.
i don't responsibility for this modification, it your own responsibility.










Move out Power PCB for open the space to move out a Display unit.
no need to unplug on any plug. except battery plug that must unplug during modify process.










Then move out LCD from LCD housing.
very carefully to remove reflextive film from back side of LCD.
then gentle to remove adhesive sticker glue and cleaning back side of LCD to clear view.
CAUTION... reflextive film is very thin film, when you remove it, it will roll as seen in this pic.
Don't remove with thick film, The thick film is polarized film.
if you remove the polarized film, you will can not see any data on LCD screen.


"Screen Cleaner" available at computer accessories store.
it very useful for LCD screen cleaning. i use this "Screen Cleaner" for cleaning my MT4 LCD to clear view.
Don't use "Thinner" or solution that can damage plastic skin. it can damage your MT4 LCD skin too.


Know your EL sheet ...
WHITE side of this EL sheet is lightning side, when ON = blue color backlight


EL sheet installation ...




















Now, you must solder the MT4-EL wires RED, BLACK, BLUE to MT4 Power PCB
RED wire is 4.8V to 9V
BLACK wire is 0V (GND)
BLUE wire is Signal Link





View point: PIN for solder BLUE wire is locate at alphabet "H" of word CCTECH






at this point, modify process was completed.
you must move all original part to origin position .... good luck ... may the LIGHT be with you ...


EL backlight is ON ...


EL backlight is OFF ...


9TURBO MT4-EL designed/production by Mr. Smith Vorapatratorn
9TURBO.COM ChiangRai, THAILAND